Skip to content

Commands

Refit Surface to Tolerance

Refit Surface to Tolerance

The FitSrf command tries to reduce the number of surface control points while maintaining the surface’s same general shape.

Steps

  1. Select surfaces.
  2. Type a new tolerance value or press Enter to accept the default.
  3. Type 0 (zero) to use the current absolute tolerance.

Command-line options

DeleteInput

  • Yes: Deletes the original geometry.
  • No: Retains the original geometry.

ReTrim: Trims the new fit surface with the original trimming curves.

UDegree/VDegree: The degree of the surface in the u or v direction

OutputLayer: Specifies the layer for the results of the command.

  • Current: Places the results on the current layer.
  • Input: Places the results on the same layer as the input curve.
  • TargetObject: Places the results on the same layer as the target surface.

For more information, please refer to the Rhino documentation.